All posts by Ant

MSP430 Launchpad used as a programmer

In this MSP430 Launchpad used as a programmer tutorial, the MSP430 Launchpad board will be used to program a MSP430G2230 microcontroller.  The MSP430G2230 is an 8 pin microcontroller and comes in a Small Outline Integrated Circuit package (SOIC), so offers the developer the chance to reduce the overall footprint of the project on a budget.  As the MSP430G2230 comes in a SOIC package, for prototyping it’s often easier to increase the package size, which allows more conventional and off the shelf components to be used during the development stage.  Texas Instruments sells a Dual In-Line Package or DIP adaptor PCB, the image below shows the board and it can also be found here.

Continue reading MSP430 Launchpad used as a programmer

Switch Debouncing Tutorial Pt/2

In this switch debouncing tutorial part 2 C code debounce algorithms will be looked at further, and their effectiveness.  All the software solutions shown will be demonstrated on the MSP430G Launchpad.  However the basic principle of operation shown in the examples, can be applied to all microcontrollers, particularly the last example which is based on some code found at Jack Ganssle tutorial, this can be easily implemented on any system using the C language.

Continue reading Switch Debouncing Tutorial Pt/2

Switch Debouncing Tutorial Pt/1

In this switch debouncing tutorial part 1 the cause and effect of switch bounce will be explained and demonstrated, then a cost effective hardware debouncing solution will be discussed, with oscilloscope captures to demonstrate the results.  The last section of part 1 will show a simple program based on the MSP430 , this can be used to see the effects of a particular switch connected to the GPIO.  Switch deboucing tutorial part 2 of this tutorial will look at further C code debounce algorithms and their effectiveness.

Continue reading Switch Debouncing Tutorial Pt/1

MSP430 Programming Tutorial Pt/1

In this MSP430 programming tutorial part 1 some of basic C operators used for programming the MSP430 will be looked at.  The GPIO port registers will then be looked at in greater detail.  In part 2 example code for the GPIO registers will be shown and explained, as well as examples for the the ADC peripheral register.   The MSP430G2253 Launchpad will be used as the reference microcontroller, the primary IDE used is Code Composer Studio (CCS). The MSP430G series family guide, as well as other useful information can be downloaded directly from Texas Instruments webpage here.

Continue reading MSP430 Programming Tutorial Pt/1